HKPRO Forums banner

sling loop eye bolt installation

2K views 3 replies 3 participants last post by  gulfstategaurd 
#1 · (Edited)
Hi Folks !! i have bought a SP89 , and found that has no front sling point .......bought a front sling eyebolt and found that it needs to be riveted in place after the front pin is removed .....

https://www.hkparts.net/shop/pc/viewPrd.asp?idproduct=144&idcategory=87

anybody has a clue on how to successfully rivet it in place without damaging the tower or barrel ? any tutorial ?

thank you !!

Karl
 
#4 ·
I use a drill bit through the loop so I do not deform it. Then a ball peen and a hand held rivet former. I tried using a lead block a couple times as my buckingblock to keep from beating up the eye ring but last time just used a steel block to buck it and cleaned up the flat spot on the ring afterwards. I have a round ball mill I chucked up in my dril press and made the rivet setter from a steel rod. Then ground the outer diameter down to fit in the recess for doming the rivet.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top