P30 mag + P2k baseplate + X-Grip + P2000(sk)???

[quikz]

Was wondering if anyone has all the above, can you pls see if the P30 magazine you have can fit a finger groove baseplate from off a USPc and if you can slip a X-grip onto the mag body of your P2000/USPc mag? Then install it into your P2000 and see if the X-grip will fill the gap of the P30 mag in a P2000?

I'd bet if you have a European hi-cap P2000 9mm mag, you could use the baseplate off of that and install it on your P30 magazine, then slip it into your US P2000 whereas it'll probably stay flush too.

Thanks,

[Montrala]

I'd bet if you have a European hi-cap P2000 9mm mag, you could use the baseplate off of that and install it on your P30 magazine, then slip it into your US P2000 whereas it'll probably stay flush too.

Euro P2000 base plate doesn't fit USPc or P30 mags, as Euro P2000 magazine (bouth 13 and 16 rounds) have body slightly narrower than USPc and P30 magazines. Also USPc and P30 base plate slips off from Euro P2000 magazines.

[quikz]

Hmmmm, I guess that leaves it to all US parts only. Then, with ALL US parts now, (USA)P30 magazine, then change out the floorplate with a (USA)USP Compact/P2000 magazine. THEN...add a X-grip to fill in the gap.

I'm wondering about this setup and think it is interesting to up the capacity of a (US)P2000 to 15-rds.

But the main thing is to see if the X-Grip would actually fill in the gap for a 9mm P2000 with a 9mm P30 magazine.