JLD PTR-91KFM4 to G3K Questions

[KE4CXP]

I just picked up a JLD PTR-91KFM4 seriel# A4xxx range and will be sending in the papers to sbr it to g3k length.
I have a few questions about going about it.

1. should I have the original barrel cut down or a new RCM one installed.

2. can I have the information on the left side of the rifle tig'ed and remarked? It just says JLD PTR-91 and the has that stupid scorpion stamping.
all of the manufacture information is on the right mag well.

3. did G3K rifles have a gernade ring?


Thanks,

Brian
KE4CXP

[mt162]

1) If you have a good barrel, it would save you some cash to have it cut down. Arizona Response does them.
2) Not a good answer but I think it's okay.
3) Yes, they have grenade rings.

[21HK]

1. PTR-91 forearm length question

2. As long as the the manufactures information is not altered there should be no problem with the remark on the left side. ..as far as I know.

3. Pre '86 DS HK G3K

[KE4CXP]

Thanks for the replys. I got out and shot the JLD today and was pretty impressed as it ate the last 140 rounds of South African ammo I had.
I will have to look into Arizona Response once the form 1 comes back.