ghilliebear2000
HKPRO Contributor

Sir,
I have a mp5 kit i purchased from lsc, that i would like to send to you for building. I would like to put it in rifle configuration. I have already purchased the fake three lug can to be blind pinned on the end to meet the length requirement. I have a few more questions to go over with you if you have time. I appreciate your time.

Thanks,

Jay
540-621-5970

This is Matt we spoke earlier thanks for you help.

Sir,
I would like to talk to you about some pricing on a couple of things. I have a K and would like to try to get it a "reverse stretch" and I picked up a parts kit for an MP5 and would like to see about getting that put together I do not have a flat but I was thinking that you might be able to help with that. Thanks for your consideration.

Hey Bud, I am back. I did indeed, (finally), get all of my funds
back from Adam for my Chumpstix build.

Sir,
I would like to price out a little bit of work with you. I recently picked up an MKE 43 at a good price and am looking at turning it into a 33K in the near future. I am aware of what you charge to rebarrel it but what would you charge to also do the following:
1. Remove the mag restriction bars in the magwell.
2. Remove the non-standard cocking tube and reweld with a German HK33 one.

Also, can you weld over the model markings on the to and re-engrave with 33K?

I appreciate your time Sir.

Respectfully,
Jason Pepper

HAPPY BIRTHDAY ! GHILLIEBEAR from an OKIE!

Jeff,

What will it cost for you to build me a Ace folder for my PTR91 model ptr32?

Thanks,

Yoni
(206) 992 2802

Hi,

I have been looking at a C93 and from all the posts here, it seems like you are the go-to guy for fixing up the rifle to almost perfect. What are your recommedations for the C93? I have read of people getting new barrels, rollers etc and sending them to you with the rifle. I'm not looking for a super tack driver, sub 2.5 MOA is acceptable to me and I am just looking to shoot cheap steel cased ammo for fun. Are the barrels that CAI uses decent or should I spend the extra and get a different barrel? Or would all these questions be better answered once I get the rifle and can see what I would like to have done based on issues I see? Thanks for your help.

Chris

Well Jeff I shopped around and found a factory HK MP5 front end at a good price with strong rifling, no bbl bulge and serviceable. The finish is worn to **** but since its a donor part that really doesn't matter much. I'll send you pics later if you want them. I don't know if it's a 12 or 16 flute, either way I'm sure it's gonna be a fun toy when its finished.

Sir, You rock. I can honestly say thanks to this site and your willingness to enthusiastically help out a new member, My quest for H&K AWESOMENESS has only just begun!