You cannot swap it with a factory selector, but my goal is this:
Take ambi selector and heat up the axle until the selector comes free (hopefully without destroying the selector). Then drill a small hole and countersync in the ambi selector where the hex screw goes on the franklin selector. Then teflon spray and heat up the franklin selector and form it into the back of the ambi selector to get it flush. Check hole alignment and then epoxy ambi selector to franklin selector. Then apply hex screw to attach to the franklin selector axel.
It sounds complicated when written, and it may not work out, but im going to try it and let you guys know how it turns out.
That is after initial testing of the unit.
Last edited by Tactician; 11-24-2017 at 03:07 AM.
Optics Planet has a coupon for 11% off THX11. Ends 11/28 11:59 PM CST. $560.69 with value shipping.
Optics planet says this is 12% off til midnight CST 11/24
Down to $554.39
Last edited by kbinmt; 11-24-2017 at 02:35 AM.
Has anyone recieved theirs yet?
^ The TFB review has pics of the BFSIII selector next to both an H&K ambi selector and an SEF selector. I haven't received mine yet, but they look different enough to require a creative solution.
And I would be very grateful if someone discovered one : ) I'd like the gun to look as authentico as possible.