I’m looking for some info on what I need to convert my SP5 into an MP5SD.
Minus the suppressor, I will go with a B&T SD barrel. But I have no idea about the other parts.
Can someone please give me a list of parts? Thanks!
Hk 416 10.5"
Hk 416C (Project ongoing)
Hk MP5SD (Project ongoing)
Hk USP9 COMPACT
Hk USP9 SD
Hk USP9 EXPERT
HK HK HK HK HK HK HK .. U.S.A Hidden Content
My dream gun, good luck with your project
Thank you, but I was hoping for a parts breakdown. id like to go as German as possible but with a B&T barrel.
SD front end. German $$$$$
SD locking piece. https://hkparts.net/product/mp5-sd-g...erman-p135.htm
Any stock will do. If you are going to SBR it. But if you do 922r comes into play.
Last edited by HK556WI; 04-04-2020 at 10:11 PM.
Lighting the Darkness
Last edited by GuntherRommel; 04-04-2020 at 10:57 PM.
What I did is the simplest route (not necessarily cheapest) HK94, MP5SD front end, MP5SD locking piece and shipped all to TSC. There are barrel shrouds available in GB. As for cocking tube, you could use the SP5 cocking tube, a lot of guys do, but it’s not correct. The SD cocking tube doesn’t taper down at the front sight like the MP5 cocking tube.
Last edited by Bestiller; 04-05-2020 at 02:06 AM.
You will need besides barrel and suppressor
Sd Cocking tube, Sd cocking tube support,Sd front sight post, Sd barrel shroud, sd rubber hand guard, o-ring for suppressor for for regular mp5 trunion. Sd locking piece.
If you want German you might as well buy the front end...
If you do... you will have the proper trunion and factory barrel... why should you do this ? You can get money for your stock trunion/barrel pressed in... since they already have to remove your cocking tube... they can replace the trunion.