WTS: Grays Guns P30/2000 Short Reset System
SOLD to Irish350
Purchased the Grays Guns P30/2000 Short Reset System (No thumb safety) SYS-HK-P30_STD for my V3 P30SK, but switched it to a 4.1 LEM. This kit won't work with the V4.1 LEM. Kit comes with control catch, new longer pin that is located on the sear/decocker and reduced firing pin block spring.
SOLD shipped, PayPal FF/Discrete or USPS Money Order.
This new product from Grayguns replicates the the short reset conversion for HK pistols found in our custom action work for many years in a convenient, easy to install kit. These parts are a precisely wire EDM cut from precision ground bar stock to exacting tolerances for easy install and exacting fit. They are properly heat treated and coated in a durable nickel PTFE finish for a lifetime of durability and smooth function.
The kit is engineered to provide several benefits:
Shortens trigger reset travel distance by approximately 33 percent
Converts the action to drive the sear directly off the safety lever – instead of transferring energy through the drop safety catch – for a direct drive connection between the trigger bar and sear
Reduced trigger over travel values
Maintains all factory safety functions
Works with both DA/SA and LEM v1, v2 and v3
Included Grayguns Firing Pin Block Spring reduces stacking in DA pull and lightens trigger pull
The parts provided – control catch, pin and spring – are designed to be installed together as a complete system.
Custom-designed Grayguns Control Latch
Custom replacement Firing Pin Block Spring
Custom replacement Sear Roll Pin
The kit works with all variants of the HK P30 and P2000 without a thumb safety including:
Will not work with the v 4.1 LEM trigger.
My Grayguns Short Reset kit Is Not Short p2000
I have successfully installed this kit and the lighter firing block spring. and the lighter trigger return spring and then back to the heaver spring trs. so far the trigger pull is much better But the short reset is no shorter than it was before.
have I done something wrong? Is this an often observed rookie mistake? Or is there some other part required? Or does the short reset just not result in a short reset in p2000?
At present trigger resets at the end of travel. DA has about 1/16" take up before engaging the hammer.
sa is very light take up to the wall now with bout 4.5 or less trigger pull. I'd guess da trigger is about 8-10lbs which is doable. da and sa have the same travel from reset to hammer drop. from hammer drop to reset is exactly the same as it was far as I can tell. however there is almost no over travel Trigger resets just at the end of travel At this point is with the trigger (if it were straight) is right in the middle of the guard.