Finally I installed my UHL trigger from German Gun Works. I don't have pics of the install but it was very easy. The UHL trigger is a complete drop in trigger. Just use a punch to remove the existing trigger, Loosen the pistol grip, Use a small punch to remove only one side of the selector switch and just drop it in and re-install the two trigger pins from the factory trigger. Yes you do have to remove the selector switch but if you are decent with tools this can all be done in about 10 minutes. The trigger is fantastic! I would highly recommend it over the much more expensive Geiselle. I used three trigger gauges to test the trigger pull and here is my results from testing them all with 10 trigger pulls and then doing an average of the 10. Timney; 10 pulls with an average of 2.41 lbs, Wheeler; 10 pulls with an average of 3.16 and last the only digital gauge Lyman; 10 pulls with an average of 2.404 lbs. If you take the 3 gauges average and divide them by 3 you come out with 2.658 lbs average on 3 different scales. I did go out and shoot the rifle and the trigger breaks very smooth and has very little movement. I was shooting sub minute of angle groups at 100 yard with the MR. Sorry i forgot to take pics because I was in a rush. Next time I am in the states I will do a better follow up with pics. I carry a Remington M-24 for work and the trigger is very similar if not better. The face of the trigger has vertical ridges and is thin and wide and has a great feel to it almost identical to the Remington trigger face. You receive 2 extra springs and an adjustment allen wrench with the UHL trigger. I paid $324.00 shipped from Germany for mine.
Same here, thanks for the report on the trigger. I've been hesitating a lot to buy one. Looks like it's a good choice.
new optic for my lightweight build.....
Schmidt & Bender 3-20X50, gotta take a pre-workout shake before going to the range!