Got new Era-Tac rails from Euro-Optic so they aren't so close to the turret. Also got a riser for the T-1. Other than an adjustable gas-block (some day) she is done.
[Insert Witty Comment Here]
My baby got a new set of eyes and mount today. [MK6 3-18x -CMR-W reticle]
NRA Life Member
Thanks Daso, those are Hornady A-Max, tipped bullets, not tracer rounds, I suppose you might not have them in Germany.
Last edited by HKGuns; 03-19-2016 at 03:05 PM.
Here are big and little brother together at last. I am still working on Big Brother, need an ERA TAC scope mount. Can't decide if I should go RAL 8000 Cerakote on the scope mount and maybe the upper. I have ordered a RAL8000 V7 Grip, Slim Line Stock, G28 sling and rear flip up site for it. But I kinda like the blackness and RAL8000 Partol V2 HG together. The retaining pins were a b1tch to set when I was trying to put the upper on. I had to drill out part of the upper receiver rear retaining pin hole and then gently hammer the pin home. I know that is not good for it but it was the only way to get the retaining pin to move forward. The upper is a Replacement MR762 Upper I bought from HKParts and the the retaining pin holes were just not drilled out well by HK. I just had them both NFA engraved yesterday at Engage Armament in Rockville, MD. They did a great job in a matter of minutes. The engraving is on the inside mag well lip. So now I am able to marry all the parts
I'll be taking both of these Marine0303's Rifle course in October. I'm going to file with BATFE this week for travel across state lines. Should give them plenty of time to process the paperwork approvals.
@Drooler , I hope you like them?
Last edited by RegularGuy461969; 03-19-2016 at 06:48 PM.