I'm trying to remove my barrel so that I can install one with the proper pin and cannot get it out of the receiver. I'm using a large wooden dowel and hammer and it has not moved at all. Any ideas or suggestions?
The barrel came out using a bigger hammer and a wooden dowel. The index pin was removed with a tile snip. I then used the shim that Marvin provided after reinstalling the barrel in the upper receiver. The barrel is now properly assembled.
On a side note the barrel nut tool from Brownells is not necessary. The barrel nut tool from Geissele does just fine and will save you some money.
Last edited by hkpsp; 04-21-2020 at 04:51 PM.