View Profile: GasGuzz - HKPRO Forums
Tab Content
No More Results
About GasGuzz

Basic Information

About GasGuzz
Location:
CO

Statistics


Total Posts
Total Posts
788
Posts Per Day
0.86
General Information
Last Activity
Today 06:39 PM
Join Date
03-24-2017
Referrals
0

05-20-2019


Page 1 of 18 1 2 3 11 ... LastLast

09-14-2019


09-13-2019


09-12-2019


09-11-2019


09-09-2019


09-06-2019


09-03-2019


08-27-2019


08-26-2019


08-22-2019


08-17-2019



Page 1 of 18 1 2 3 11 ... LastLast

130 Likes

Page 1 of 9 1 2 3 ... LastLast
  1. Disregarded9-side
    Disregarded9-side liked post by GasGuzz On thread : I should have been warned
    Is it German or USA?
    Liked On: 09-15-2019, 10:58 PM
  2. jdl2
    jdl2 liked post by GasGuzz On thread : Streamlight TLR-7
    Yes, it will mount. Fit inside and not past the muzzle, no.
    Liked On: 09-14-2019, 12:21 AM
  3. Wolfrandal
    Wolfrandal liked post by GasGuzz On thread : USP Compact 45 auto (tactical) rarity
    HK's have matching serial numbers on box, frame, not rare unless maybe a P7 box. Is it roll marked CT on the slide, that's more desirable. What is no visible import marks, faded or absent?
    Liked On: 09-14-2019, 12:06 AM
  4. philly34581
    philly34581 liked post by GasGuzz On thread : P30 vs P30SK
    As Superstar alluded, it depends. I have both P30/P30SK and in IWB the SK barrel makes a difference. In fact, I carry more my P2000 vs. P30, it's smaller than the P30 and larger than the SK. But...
    Liked On: 09-11-2019, 12:14 AM
  5. WolfieRules
    WolfieRules liked post by GasGuzz On thread : P30 vs P30SK
    As Superstar alluded, it depends. I have both P30/P30SK and in IWB the SK barrel makes a difference. In fact, I carry more my P2000 vs. P30, it's smaller than the P30 and larger than the SK. But...
    Liked On: 09-10-2019, 11:09 PM
  6. ca survivor
    ca survivor liked post by GasGuzz On thread : USA Proofed VP9?
    US guns are not required to be ‘proofed’, US guns are serialized. Euro gun are proofed and marked accordingly, US guns don’t have the markings because they are not required and not as cost savings....
    Liked On: 09-10-2019, 07:13 PM
  7. DarkeWolf
    DarkeWolf liked post by GasGuzz On thread : HK P30SK and Keystone Munitions 147gr 9mm: warning
    Did you feed the SK’s from the same box/lot? P L/SK should have the same chamber. On/slide-open or off gun, drop a round in the barrel/chamber and check if they headspace the same.
    Liked On: 09-07-2019, 11:16 PM
  8. mew
    mew liked post by GasGuzz On thread : Another HK VP9 Trigger Bar Spring Failure
    Maybe a glued 4th rev will resolve it – insanity. I imagine the 3rd/white rev they changed/increased the profile to provide more bearing surface for the adhesive/spring – but remains a glued design...
    Liked On: 09-07-2019, 07:24 PM
  9. WolfieRules
    WolfieRules liked post by GasGuzz On thread : HK P30SK and Keystone Munitions 147gr 9mm: warning
    Did you feed the SK’s from the same box/lot? P L/SK should have the same chamber. On/slide-open or off gun, drop a round in the barrel/chamber and check if they headspace the same.
    Liked On: 09-07-2019, 02:21 AM
  10. jdl2
    jdl2 liked post by GasGuzz On thread : Sight Selection
    Nice setup on the P2000 Trijicon/Dawson hybrid. Did it change the 3-dot OEM front/height rear/width? Interesting and thanks for the insight on different type fronts/rears. I require low-profile...
    Liked On: 09-07-2019, 12:31 AM
  11. Wonder9
    Wonder9 liked post by GasGuzz On thread : New P30L with slight surface rust on barrel
    While I don’t doubt the NIB stated, the thing is any-one/seller can post such. All my HKs were NIB and wet, (all HKs are test fired) with minimal/almost-invisible breech/barrel/hammer wear/markings....
    Liked On: 09-03-2019, 06:24 PM
  12. WolfieRules
    WolfieRules liked post by GasGuzz On thread : New P30L with slight surface rust on barrel
    While I don’t doubt the NIB stated, the thing is any-one/seller can post such. All my HKs were NIB and wet, (all HKs are test fired) with minimal/almost-invisible breech/barrel/hammer wear/markings....
    Liked On: 09-03-2019, 04:25 PM
  13. WolfieRules
    WolfieRules liked post by GasGuzz On thread : VP9SK slide release stiff
    That’s not an HK part. Saturday I was out with my P2000/P30SK, it takes more ‘effort’ to slingshot than to thumb the release. If you can rack the slide, you should have enough dexterity/strength...
    Liked On: 08-26-2019, 08:51 PM
  14. astrom00se
    astrom00se liked post by GasGuzz On thread : USP 45 Tactical: Showing Her Off
    A German BK USP45T, instant classic (I'd even keep the sm mag release).
    Liked On: 07-27-2019, 12:20 AM
  15. GLC
    GLC liked post by GasGuzz On thread : USP (F) 9mm vs. 1911 .45 acp (steel frame)
    My 1911 are 9mm in 4.25”/Comm Alloy and 4”/Compact Steel, either with felt recoil negligible. If the Army didn’t require otherwise you’d think JMB designed the 1911 for 9mm, but that’s another...
    Liked On: 07-24-2019, 05:02 PM
Page 1 of 9 1 2 3 ... LastLast
iTrader Profile Recent Ratings
Feedback Score:
Positive Feedback:
0
0%
Members who left positive:
Members who left negative:
0
0
Total positive feedback: 0
Submit Feedback For GasGuzz
View Complete Feedbacks for GasGuzz
  Past
Month
Past
6 Months
Past
12 Months
  0 0 0
  0 0 0
  0 0 0