HKPRO Forums banner
buffer
1-8 of 8 Results
  1. HK CLONE TALK
    I had always read that this was a MAJOR no no, but something occurred to me today. When I first got my Z-43, I was surprised to see that the endcap had the same rubber H buffer as you would see in a 9mm gun, instead of the mechanical buffer found in 93-type stocks. I had known ahead of time that...
  2. HK LONG GUN TALK
    I've been cleaning my parts kit with Hoppes no 9 synthetic and I noticed something odd when cleaning the hole on the G3 buffer. When I was drying everything off after a soak, I noticed a green liquid on my paper towel. I might just be totally ignorant, but does anyone know what this is and if...
  3. HK LONG GUN TALK
    Just a couple questions, cant seem to find definitive answers for this... Does anyone know the actual LOP on the regular(non4-position)A3 stock? Anyone got any good videos or something showing how to make additional position notches in the sliding bars? Does a rubber buttpad come on any of the...
  4. HK LONG GUN TALK
    I apologize if this has been asked before, but I am unable to find whether or not a 300 blackout upper on an MR556A1 lower would require any changes to the buffer to cycle properly? Thanks
  5. HK416 and HK417 HQ
    Hello all, I have been trying to do some research out there and there doesn't seem to be much on the tungsten buffer/ buffer spring and its compatibility with non HK uppers. I was thinking of possibly buying a DD upper to put on my colt 6920 lower that has the hk buffer/spring ( I have a hk416...
  6. HK ROOKIE CORNER
    Hello, I'm new to the site and i have searched for two days with no luck finding a thread to my question so I appolagize if there is. Just purchased a Magpul PRS stock to put on my PTR 32. Simple enough to understand. I took off my factory stock, took off the two screws holding the buffer in...
  7. HK HANDGUN TALK
    Can anyone tell me how to replace the buffer pad on an SP 89. The old one disintegrated like it was made of wax. I'm not sure if the Hopps Cleaner caused that but the bottom line is I have a new buffer but can't figure out how to take the assembly apart to put the new buffer in. I'm not sure if...
  8. HK CLONE TALK
    So I bought a PTR 91 "GI" back in January. I wanted to put a wide hand guard on it, which means also swapping the stock to match the OD. Anyways, the stock is giving me a little trouble. I got the original stock off, which DOES have the large rear buffer screw that is held in with red loctite...
1-8 of 8 Results
Top