Search Results for ‘cetme’

Hi all, First post so let me know if this is the wrong place. I am attempting to build an HK91/G3 clone off of a CETME C parts kit. For now I am looking to get the rifle operational then I will work on buying correct clone parts. So, so far I have the CETME parts kit (includes everything...

So I picked up a C308 for dirt cheap. Figured if there was anything wrong with it I could fix it. Second time out to the range it locked up on a round. It had a rattle can job that was also put on the bolt. Dude helping me put some lubricant on the bcg and it washed away all the paint on the...

Hi all, was wondering if anyone has successfully installed both the wood handguard and buttstock from a CETME Model C onto a PTR-91. I don’t have issues with the stock, however the handguard pin holes on the CETME wood handguard are just slightly off from the PTR’s thus any OEM pin or screw will...

I have what I THINK is an HK three-point sling that does not quite look like any others I find on the net. Maybe it could be CETME (sorry for swearing ;)) It is made of green canvas webbing and neither the front nor rear attachment points, nor the lenght adjustment buckle looks like the others I...

I'm new to the whole game of owning a Cetme and I am aware of the bad reputation with Century. I am having the issue where when the bolt carrier group is fully forward it is impossible to pull the charging handle all the way back without hitting the stock on the ground and pulling down. I have...

I recently purchased a CAI C308, today I took it to the range for the first time, It cycled beautifully, and it did not jam once, but every few rounds I had FTFs due to light primer strikes. I checked to make sure the bolt was seated properly and everything looked OK. I also tried different mags...

New to the forum. I joined because i have been wanting to build a CETME/HK 91. Started out with a parts kit from APEX and now have everything for 922(r) other than the receiver. After learning about the build process, it seems I've bitten ff a little more than i can chew in regards to the...

Edited 2/13/14I changed out the locking piece and put a heavier spring in. The bolt gap is now .009 and if you put a little effort .010 fits. The rollers that are in it now are .313 so what size do I need to get to proper bolt gap. The length of the bolt size is 1.839 Edited 2/13/14 My cetme...

I am having an issue with my CETME's firing pin spring. The one I got with the rifle seems to be to light and doesn't hold the firing pin back creating a slam fire situation. I got a new spring and this spring is much heavier. When you shoot the rifle the bolt stays back. Got the replacement...

Hi folks, I'd appreciate your comments and advice, please: I bought two surplus 5-round steel magazines for my PTR-91. Images at the bottom of this post. They arrived coated in what I assume (yes, I'm a rookie) is Cosmoline. I want to disassemble the magazines so I can thoroughly clean and...