HKPRO Forums banner
1 - 7 of 7 Posts

·
Registered
Joined
·
91 Posts
Discussion Starter · #1 ·
Anyone have experience w/ Top Notch brand? Michael Machines brand? My main concern is reliability. Does it make sense to permanently install a fake suppressor on a factory barrel to make it 16 inches?
 

·
Premium Member
Joined
·
2,882 Posts
I have the MM one and I just installed in last Friday. It is very nicely done, high quality! (Bolt is as well.) I shot about 50 rounds through it and as far as I can tell it is very accurate.

I would never waste a factory barrel with pinning on a fake can. While the MM barrel will cost you around $400, the factory barrel is very rare and very expensive; if you have one, keep it pristine.
 

·
Premium Member
Joined
·
2,882 Posts
Lohe, i am with you on the .40, but you know as soon as one was available, we would have the same nonsense with mag availability and $$$$.
 

·
Premium Member
Joined
·
2,882 Posts
Yes, today this is true. I doubt it would be if there were lower priced conversion options for folks converting from USCs.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top