HKPRO Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
78 Posts
Discussion Starter #1
I am going to try and attach a pic. I noticed that the rear right frame rail doesn't seem to be engaging the slide rail groove as fully as the left side. I found one pic on the board that looked similar, but I wanted to see if this was pretty typical or something to worry about. This pic sucks but it is the best I could do tonight.

 

·
Registered
Joined
·
20 Posts
Personally I would have it sent back to HK for warranty work. It may be fine but it would make more sense to have the manufacture tell you it's ok.
 

·
Registered
Joined
·
2,783 Posts
Your pistol is fine. Go to the gun shop at look at a dozen or so. You will see they are all like that with a little more gap on one side than the other. This harms nothing either function wise or accuracy wise.
 
1 - 5 of 5 Posts
Top