HKPRO Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
368 Posts
Discussion Starter · #1 ·
Does anyone have an accurate / to-scale model of the HK M4 Magwell and button? I'm also looking for one of the magazine body, floor-plate wouldn't hurt but not needed.

I was to test how feasible it is to print them using current 3D printers / glorified-glue-guns.. There's a material in particular - fiber reinforced nylon... which I'd like to try to see if the printed parts would be sturdy enough to actually use..
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top