HKPRO Forums banner

1 - 10 of 10 Posts

·
Registered
Joined
·
83 Posts
Discussion Starter #1
So I happened upon an 80% 416 D lower awhile back and Im wanting to get it engraved with a serial number. Im not too much into the "MAKE EVERYTHING LOOK SPOT ON" thing but obviously I would atleast have the lower look correct with the location of the serial number. Does anyone happen to have any pictures of there 416D lowers so I can get a reference on where to put the serial number.
 

·
Registered
Joined
·
120 Posts
Go to the 416 section here on HKPro, there are plenty great pics on there.

Did you get the 80% anodized yet ?

I think I have the text file for the HK416D blah blah words etc somewhere.
 

·
Registered
Joined
·
487 Posts
Will a standard AR jig work to finish the milling? Or do you need a special jig for the 416 clone lowers?
 

·
Registered
Joined
·
487 Posts
1 - 10 of 10 Posts
Top