HKPRO Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
237 Posts
Discussion Starter · #1 ·
I have put a half hour in trying to get this damn barrel in the receiver. Both have been cleaned, then oiled, then greased (different times). I've tried perfectly aligning it and at most I can get it about a half inch in and then struggle get it out...
296609
 

·
Registered
Joined
·
30 Posts
Freeze the barrel for 4hrs
 

·
Registered
Joined
·
43 Posts
Freeze the barrel and heat gun the upper always worked for me.

Get a heat gun since they are far more efficient than a hairdryer. I use the heat gun to prep small parts for cold blueing, remove magazine tubes on Benelli M4's, and sometimes for heat shrink. My Harbor Freight one has done a lot of projects....surprised it is still going since the price point is lower than other brands.
 
1 - 6 of 6 Posts
Top