HKPRO Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
184 Posts
Discussion Starter #1
Is there a general consensus on which is the better route to go for a trigger, sear, and hammer for 922r compliance? I'd think that milled (Blackwing) would be the best route but I can find next to nothing about them online. What do you all think?
 

·
Registered
Joined
·
1,802 Posts
I have a both a blackwing and PTR hammer and sear. Both are nice pieces but I'll tip towards blackwing. However I do not have one of their triggers. They have been listed as coming soon for years on RTG
 
1 - 2 of 2 Posts
Top