HKPRO Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter #1
Hi every one, I just measured my bolt gap on my HK 41. It measures with my feeler gage .013 or .330mm. Is it time to change out my rollers? If so what size do I need to put it at the Top of the Ideal Range ? From what I have read here on this site I am still in the safe Range but getting to the low end of the safe range. Should I change the rollers now or wait until it gets down to .010 Range? Or can I change the bolt locking piece I have a Brand new one. Also I have a set of +2 rollers in my spare parts box. Please advise. Thanks:wink:
 

·
Registered
Joined
·
20 Posts
Discussion Starter #3
Thanks I will not touch it, But I will keep shooting it. My Favorite Hk, not a safe queen, This is my Shooter.
 
1 - 3 of 3 Posts
Top