HKPRO Forums banner
Cancel

C93 paddle mag release install question

3823 Views 11 Replies 6 Participants Last post by  calawoof, 
K
So from my research the center of the hole for the paddle mag release should be 15.5mm/ .610" straight down from the center of the mag catch hole. I measured and scribed two lines that intersect to that point. However, when I install my clipped trigger group, the hole does not line up with my mark. The trigger pack hole is low and back from my measured center mark. So go with the measurements or the trigger pack location ? It's a Century C93 with a lower I clipped myself. Just checking, you know measure 1,000 times drill once, right. I'm a machinist by trade so I have the skills and tools just need to make sure I'm in the right spot. -Thanks
Reply
Save
Like
1 - 3 of 12 Posts
hkshooterusp
Where did you get those numbers?

When I drill them I use a clipped lower to mark my hole. Install, center punch the shelf in the center of the hole, drill it. Never had a problem. I figure there's no better template to mark the hole than an original SEF housing.
Reply
Save
Like
hkshooterusp
How far off is the hole vs your marks?
Reply
Save
Like
hkshooterusp
I think you found your problem. That weld isn't normally there. Well, on a push pin gun it isn't.
Reply
Save
Like
1 - 3 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
HKPRO Forums
A forum dedicated to and laser-focused on Heckler & Koch firearms, Heckler & Koch accessories and the owners and enthusiasts that love them! Come join the discussion regarding HK pistols, long arms, NFA arms, HK accessories, HK history and trivia and more.
Full Forum Listing
Explore Our Forums
HK HANDGUN TALK HK CLONE TALK HK LONG GUN TALK HK NFA TALK HK416 and HK417 HQ
Top