HKPRO Forums banner

1 - 4 of 4 Posts

·
Premium Member
Joined
·
465 Posts
Discussion Starter · #1 · (Edited)
Just got my CA89K today and installed the foregrip (AOW'd). I can't figure out how to remove the trigger pack from the lower. What's the trick?

I did search for those that are wondering.

Jake

Edit: Got it! Thanks for the help guys. That wasn't too hard.

*******Another question:

I'd like to use a metal SEF frame with this gun. The frame fits the receiver perfectly and the triger pack fits into the metal frame beautifully as well. The ambi trigger pack and the SEF selecter don't fit at all (the selector is long enough, but seems too small diameter to fit the pack). What trigger pack do I need for semi function in this metal SEF frame?

Thanks in advance,

Jake
 

·
Registered
Joined
·
2,937 Posts
How to...

If you look inside the pack there is a lever above the safety switch/axel

You just release the hammer,push that lever down and move the safety to the vertical position, which would be one click down below safe.

Then the switch should release and pull apart from the grip and the pack slides out.

Do yourself a favor and trash that trigger pack and buy the following...

HK FBI Semi Lower, HK strutted hammer, HK 9mm hammer spring, HK MP5 Ejector (trust me, its worth it) Buy from Adam Webber or Gordon Miller

Adam does the best damn clip and pin job that I have ever seen FYI
 
1 - 4 of 4 Posts
Top