HKPRO Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
158 Posts
Discussion Starter · #1 ·
Hi. Looking thru the forums looking for a Emag 10/20 or 10/30 magazine. I found the PMag 10 round conversion ,but they seem to need some physical modification which is not mentioned in detail of how to do it. Any recommendations besides the Lancer 10 alternative? Thanks.
 

·
Premium Member
Joined
·
1,312 Posts
Calguns is a better resource - you can install a pop rivet to limit
The follower - or a block internally.
Some have installed air soft fake rounds
And epoxying the block to the follower allows
For cleaning of the mag if needed
 

·
Registered
Joined
·
15 Posts
You can pick some up at Calegalmags.com, or Riflegear. Calegal has 10/30 Emags as well as USGI, and I believe Riflegear has USGI 10/30s. Both have Pmags.
 

·
Registered
Joined
·
5 Posts
Take a Dremel to the front of your pmags...you just have to take of a little of the front of the top ridge. Probably less then an 1/8 of an inch. It should take you less than a minute and it does no harm to the pmag.
 

·
Registered
Joined
·
28 Posts
Take a Dremel to the front of your pmags...you just have to take of a little of the front of the top ridge. Probably less then an 1/8 of an inch. It should take you less than a minute and it does no harm to the pmag.
Can you please post a piс, showing which part of the pmag exactly?
 
1 - 5 of 5 Posts
Top