HKPRO Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
48 Posts
Discussion Starter · #1 ·
Was considering getting a simple cerakote job on the barrel of my VP9. Just about like this guy here: https://goo.gl/images/76lXep

However, my local cerakote guy warned me that this isn't going to hold up under frequent use.

Has anyone done this to a barrel? Did it start looking like crap pretty quick? Or are the parts that "wear" not visible due to being under the slide?

Thanks for any help.
 

·
Registered
Joined
·
143 Posts
I had my p30sk cerakoted, including the barrel. The action will create makes on it over time. Although cetakote is durable I think the barrel is the part most likely to mark up. I simply went with a distressed look.

You could keep it black, add the clean red to the trigger area but then distress the barrel with red and black. It would look sweet!



 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top