HKPRO Forums banner
1 - 1 of 4 Posts

· Premium Member
8,570 Posts
Not sure about the metal lowers, but the plastic lowers sold by are done by Urbach - he uses CA glue (heavy duty superglue). I stood there and watched him make mine. JB weld would work well, you just have to be a little neater as it won't come off, and will show up more if you're sloppy.

If you mess it up with CA, you can use solvent debonder to remove it and start over.
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.