HKPRO Forums banner
1 - 1 of 4 Posts

· Registered
Joined
·
39 Posts
I just clipped and pined my lower it was my firt one that ever did and it came out pretty good. After i clipped the lower i had a pin and cut it down to size and then i just used J.B. weld the one that sets up in about 4 min. It seems to be holding pretty good so far.
 
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top