HKPRO Forums banner

Coharie V94 Parts???

801 Views 4 Replies 2 Participants Last post by  Litigator123
Looking for the proverbial needle in the haystack, but... here it goes. I'm looking for a small piece - the small feed guide or mag stop that fits into small holes on either side of the trunion just above the top of the mag well. Vector has none. Coharie is long gone. Anyone have such a piece (or know where to get one) by chance?

Thanks.
1 - 5 of 5 Posts

· Registered
Joined
·
326 Posts
Discussion Starter · #3 ·
On a .40 or 10mm ?
You mean these:
View attachment 70345
THAT'S IT!! Exactly. .40 cal. They seemed just pined in there. One blew out and had the gunsmith drill a hole from the outside to weld it back in, but it popped out again. Where can I get these? They don't even seem to be listed with the flats or even full kits?
 

· Registered
Joined
·
326 Posts
Discussion Starter · #5 ·
Try RCM or hkparts.net, if not, you might have to get a new trunnion and remove them.
Don't know if those are supposed to be replaceable parts or not.
I checked HK parts - they don't have them. The problem (I think) is that HK doesn't use them (do they?) These parts seem to be unique to Coharie, if they are, no HK place will have them.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top