HKPRO Forums banner
1 - 3 of 3 Posts

·
Vendor
Joined
·
2,159 Posts
Discussion Starter · #1 ·
I am having difficulty getting my FSC91 to time correctly on my G3k. I can get it close, but the set screw will only fit in a notch just off to either side of TDC. To ensure its on good. I put a crapload of Rockset, and could get it off, but I would like to be able to get this thing timed without having it pinned since it is a SBR.

What is going to be the best way to do this. The following picture is a still of a video shot, which shows the timing issue.



Oh, And here is a video of it in action on the 2nd mag through her. Shooting some wolf steel case. Had one FTF that fired next time, and some sort of Failure to feed error, nothing big. This cleared up during the day. This was my first time taking it out other than Ghillies test shots. I have only put about 100 rounds through her, so I have not broken her in yet.


**I do not know how to embed**

H&K G3K clone A3 stock - YouTube
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top