HKPRO Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
148 Posts
I had the same issue on a C93 and rectified it by just touching the bottom of the brake with an endmill to allow it to clock properly when tight. If the G3K brake also bottoms out against the barrel it should work the same. Shims didn't seem like an option for me and I thought this was a better option than removing material from the barrel.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top