HKPRO Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
104 Posts
Discussion Starter · #1 ·
If I were going to cut a slot (verticle mill) in a FA bolt carrier to convert to SA... is there any exact depth I should cut to...

The width of the slot seems to be the same as the exiting slot that is curved (has a roundish shape)

Will light cuts with HSS tool work or is the steel extraordinarily hard...

Are reinmetal bolts worth looking for? Any suppliers?

LO
 

·
Registered
Joined
·
630 Posts
Why mess with it? I would leave it as a full auto bolt, there is nothing illegal about it in a semi-auto gun. As a matter of fact, my VECTOR V53 came with a full auto bolt carrier.
 

·
Registered
Joined
·
223 Posts
I would leave the bolt carrier alone unless you are in one of those states which does not allow MG parts. In fact when you go to sell the weapon the FA carrier may bring you a few extra dollars.
TC
 

·
Registered
Joined
·
611 Posts
I would leave it alone, or put it up on the board to do a trade for a SA carrier. In fact, I have an SA carrier which I would trade with you.
 

·
Registered
Joined
·
306 Posts
Picture from MWDG3

 
1 - 6 of 6 Posts
Top