HKPRO Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
1,511 Posts
Discussion Starter · #1 · (Edited)
Step one: remove these parts from the rail.





Step two: made two cut out on the cover so the two screws can pass thru.




Step three: Finished, I did it on a mill. Install the cover first, then re-install parts from photo 1.



 

·
Premium Member
Joined
·
4,132 Posts
Nicely done. I had wondered about this
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top