HKPRO Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
257 Posts
Discussion Starter · #1 ·
okaaaaaaaaaaaaaaaay , what a load of hillary to have to deal with...
got my p2k from the CCCPK(Ca) today , went to swap out the backstrap and find some clinton has walked off with my very highend rollpin punch set...
aaaaaaaaaarrrrrgggggghhhh!
so i went over to sears , no metric RPP's in stock or in the catalog ...
then i went over to the 'specialty toolstore' , nst-sol ...
i finally bought a 1/8" mayhew of .1250 dia...(should be .1181)...
i was able to remove the pin with an undersized drift , DO NOT USE THE 1/8" TO DRIVE THE PIN ALL THE WAY THRU , IT WILL ENLARGE THE HOLES !!!...
seated pin to grip level with a plastic mallet , then finished seating with the 1/8"...
the pistol seems to fit best with the large backstrap ...
wasn't there someone who needed an XL backstrap awhile back ?
got 10 more mags on the way fron cdnn , now to have a holster and magpouch set made for it...
 

·
Registered
Joined
·
179 Posts
FWW

I used a finishing nail to tap that out...I know I know as a HK owner I should have better tools but it works. If you put the head against the pin and tap the pointy end with hammer.

Must get punch set soon though.

Just my .02

hk_mtbr
 
1 - 2 of 2 Posts
Top