HKPRO Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
279 Posts
Discussion Starter #1
greetings from ireland.....

i was on the range last week and a guy with a standard usp9 ( same an myself) gor chatting... hes going to put a match trigger on his but says that there is machining involved in the instalation.


is that right ???

any all help would be appreciated...

slan
 

·
Registered
Joined
·
802 Posts
No machining involved. There is some "tweaking" if the gun isn't within the serial numbers listed. Basically early USP9/40 with the all metal hammer and rebound springs, will not be a drop in installation.
 

·
Registered
Joined
·
279 Posts
Discussion Starter #3
if it is an early model so how do i get it to fit ??
 

·
Registered
Joined
·
279 Posts
Discussion Starter #5
fatboy.... no chance .. they had primitive tools... and too small to reace a proper height desk..... presumably no1 would take them seriously wither :p:p:p:p:p
 

·
Premium Member
Joined
·
293 Posts
I have a KE dated USP with all metal hammer, rebound spring and one piece catch. In my case, the Match trigger kit added the half cocked position and it cannot be made safe when the hammer is fully down. Other than that it has worked fine for several years now.
 

·
Registered
Joined
·
886 Posts
KG and later, the match kit should fit, otherwise the sear, hammer and a few other parts should work and. the trigger and return spring are the worst part to install.

Bill
 
1 - 7 of 7 Posts
Top