HKPRO Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Hey guys, I bought a G3 bayonet and the release pawl was stuck and could not be pressed. When I punched out the roll pins to find out what was going on instead of a spring there was a metal pin in its place preventing it being inserted into the bayonet lug. Does anyone know where I can find a replacement or equivalent spring?
 

·
Registered
Joined
·
1,194 Posts
You could try a hardware store.
 

·
Registered
Joined
·
1,194 Posts
Find a small nail that fits where the pin goes so you can temporarily assemble the bayo in the store as you try various springs until you find one that works. If the springs are too long you can always trim to length if you find one of the right diameter.
 
1 - 5 of 5 Posts
Top