HKPRO Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
279 Posts
Discussion Starter #1
greetings from ireland every1,

just a question....

after modifying a G3 SG1 trigger group to semi auto only does it lose the sweet trigger pull after pressing in the "button" behind the trigger ??????

any/all info greatly appreciated !

slan

phillip
 

·
Registered
Joined
·
50 Posts
A new toy ???
 

·
Premium Member
Joined
·
8,625 Posts
No, it will not lose the set function. The SG1 pack's 'set' function works in the semi-auto position as well as in the full auto position. There is one piece that pivots around the catch hole in the front that will have to be modified or maybe even fabricated to work in the new sear spring pivot hole. But most of the mechanism that makes the set function work is in the rear of the pack where no modifications have to be made other than installing a blocking pin that prevents the trigger from being pulled back all the way to the full-auto position.

Functionally, that one block would make it semi-only and impossible to fire in full-auto mode even if the factory catch and trip lever were installed, but that's not good enough to satisfy the ATF. But how any of that applies to Ireland, I have absolutely no idea.
 
1 - 3 of 3 Posts
Top