HKPRO Forums banner

1 - 2 of 2 Posts

·
Premium Member
Joined
·
1,065 Posts
Discussion Starter · #1 ·
Can a G36K barrel be cut down to G36C length without having to modify the gas block location?
 

·
Registered
Joined
·
283 Posts
Nope, the gas block sits closer to the receiver on a C barrel, so you would need not only the barrel work to relocate it, but also a new op-rod. If you can find one, I think getting a "C" barrel would be more cost effective in the long run.

Good luck!
 
1 - 2 of 2 Posts
Top