HKPRO Forums banner

Gunkoting a G3

1191 Views 6 Replies 4 Participants Last post by  Xenophobiac
Hi, everyone...

This is my first post on this site, and I have a question regarding the application of Gun-Kote to a G3 type rifle. It's actually a PTR-91 (not HK, I know, but I didn't win the Powerball to be able to afford one) that I am building, and want to know if after application, would that change the tolerances of the bolt carrier and bolt? I pressed in the barrel to .016" for headspace with the original finish on the carrier and bolt. I'll be sandblasting the carrier to prepare it for application of Gun-Kote. KG Industries says that it will only add .0004" to the measurement. Will this cause a problem? Also, I know this does not quite belong with this thread, however, I didn't want to wade through the other threads; this concerns barrel pressing. I found that a 10 ton press isn't needed for barrel installation. I found that coating the portion of the barrel that contacts the trunnion with anti-seize grease, inserting the barrel into the breech side of the trunnion, and pressing it in with a hub puller works just as well. Just make sure to use an impact wrench with the puller; if you don't, you will get quite the workout. Take it slow, measure often, and save yourself a couple hundred bucks by using that method. Just throwing it out there. Any advice on the first issue I posted is appreciated.
1 - 1 of 1 Posts

· Vendor
Joined
·
6,574 Posts
I would repark the carrier ... paint is not a good ideal for the carrier . here is my number if I can help you .. 918-696-8715 or 918-871-3939 . welcome to Hkpro ..
If you have not pin your barrel call me ..
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top