HKPRO Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
I was wondering if you guys oil the hammer area on your Hk's?


Some of these parts look polymer, and I'm not sure if oil should be applied.

For example: the sear, catch, sear actuator latch, and hammer axle. I'm pretty sure these are all made out of polymer, not certain.


Any advice will be much appreciated.
 

·
Registered
Joined
·
865 Posts
When you field strip the pistol for maintenance just place one that's (1) drop of quality gun oil where the hammer & sear meet and your good to go!
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top