HKPRO Forums banner

1 - 15 of 15 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter · #1 ·
What does the factory barrel thread protector look like? I have seen a couple of different ones. Mine has a ribbed edge about 1/8" wide which sticks up almost the same. My buddies is more knurled. Which is correct? Could you post a pic so I could see what it looks like.

Thanks,

Bill R.
 

·
Registered
Joined
·
1,342 Posts
Here is mine if you can see it okay. This is just the stock thread protector they sell at HKparts.net.

 

·
Registered
Joined
·
24 Posts
Discussion Starter · #4 ·
Thanks for the reply. That is what my buddies looks like so not sure if mine is home made, aftermarket or just a different model.

Bill
 

·
Registered
Joined
·
1,791 Posts
The same one came on my MARK 23 , i didnt like it so i bought an AAC one just right
 
1 - 15 of 15 Posts
Top