HKPRO Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
304 Posts
I don’t have this exact one but have used the same type for P30. It looks like a good idea but I have had feeding issues. It feeds fine for the first 10rds or so then starts nosedive on the rest. I believe it feeds fine when the spring tension is high on a full mag but the tension become less and less until it’s too weak to push up the cartridges.
 

·
Registered
Joined
·
54 Posts
wow i didnt even know they had these. i already have the elephant foot on mine and it barely fits in the bedside safe.
but if there is potential for failures like others have mentioned above, i dont know if i would trust it.
 

·
Premium Member
Joined
·
3,978 Posts
those have been on HKParts' page for quite a while. as far as I know, they've never been available.

I was pleasantly surprised recently, when the HKParts HK45 +3 extensions became available again. they had been out of stock for quite some time. I prefer their +3 extensions.
 
1 - 6 of 6 Posts
Top