HKPRO Forums banner

HK 45c decock problem

524 Views 7 Replies 4 Participants Last post by  Wsr
Hey guys, so I traded one of my pistols for a 45c. Has a 5/6 detent in it and ambi safety. Gentleman had it set up like a 1911 in where the safety does not work as a decocker. Anywho, swapped out detent to 1/2 and safety to only left side......still will not decock.....what am I missing?? Thanks in advance, tried looking it up but my Google/Forum foo is weak by any standards! Been on here for a bit, sad that this is my first post!
1 - 2 of 8 Posts
I would remove the detent plate and put a thin layer of lube (not oil) between the backside of the detent plate where it rubs the frame. Then work it in a few times until the movement improves. Also check to make sure the sear axle is flush against the top surface of the detent plate.
So it is a LEM (not DA/SA) and an HK45C with a stop screw? Or is it a USPc 45?
1 - 2 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.