HKPRO Forums banner
1 - 20 of 99 Posts

·
Registered
Joined
·
612 Posts
Discussion Starter · #1 ·
According to Classic Firearms, "These are brand new pistols that were built to fulfill a Law Enforcement contract in Europe but the buyers backed out last minute and we were able to swoop in and pick up the entire lot at a tremendous deal."

Please buy them all, so I don't have to worry about buying them. Spending $1,500 on firearms and ammos monthly isn't healthy for me...

https://www.classicfirearms.com/hec...Y2xob3Jpem9uQGdtYWlsLmNvbQ==&utm_source=ATEAM
 

·
Registered
Joined
·
221 Posts
Dammit TooSixy... I knew I should have looked here first... LOL I don't mind the mark so much for that price... I loaded up so to speak. Just unbelievable they are going that low for a new LEM (not even my favorite) HK. I ordered 3. One to keep and never shoot, one to shoot the crap out of, and one to flaunt.. Cause, why not? hahaha
 

·
Registered
Joined
·
422 Posts
I am no expert, so bear with me: Is that big lever on the rear side of the frame a safety?


Sent from my iPad using Tapatalk
 

·
Registered
Joined
·
293 Posts
whats with the additional engraving? I see a tan usp tactical on gb with a huge engraving HKPRO on it that was a deal breaker for me. I would like this but man that engraving just is killing me
 

·
Registered
Joined
·
422 Posts

·
Registered
Joined
·
15 Posts
Ambi safety is an easy fix.
Not liking the import marks, wondering if its only applied to the surface or engraved into the slide.
Thinking Gray Guns + Cerakote might be the way to go.
 

·
Registered
Joined
·
612 Posts
Discussion Starter · #14 ·
whats with the additional engraving?
. The engraving is a requirement for ALL import firearms. Since these USPC are imported from EU by private party, it is required to be engraved. Some importers would engrave at the less visible spot. Obviously, this importer engraves on the slide.

You see the same engraving on all recent imported Mosin, or Sig P6, etc
 

·
Registered
Joined
·
706 Posts
Just jumped on one of these bad boys… so a bit confused as to what I am getting trigger wise though. LEM w/ Ambi Safety? Sounds crazy, but why not for the price...
 

·
Premium Member
Joined
·
3,298 Posts
Over a $300 savings, not a bad deal. I have a Stainless or I would jump on it. If used as a carry gun that will most likely get holster wear the engraving should not be a big deal.
 
1 - 20 of 99 Posts
Top