HKPRO Forums banner
1 - 1 of 1 Posts

97 Posts
Discussion Starter · #1 ·
I picked up a used UTL for cheap because it didn't work. I was hoping it was just a's not. The good part is the bezel and bulb are good and for what I paid, its worth it.

I ohmed out the light and the issue is in the switch mechanism. In all positions, it doesn't complete the circuit. Does anyone know of a way to take it apart to where I can check the contacts?

I did email Insight on the off chance they can do anything, but you never know until you ask right?

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.