HKPRO Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
303 Posts
Discussion Starter #1
Will a HK21 buffer fit in a standard G3 stock? Is it too long?
 

·
Registered
Joined
·
1,733 Posts
Will a HK21 buffer fit in a standard G3 stock? Is it too long?

I'm pretty sure that the 21 buffer wouldn't allow the cocking handle to be fully retracted to cock the hammer.
 

·
Registered
Joined
·
303 Posts
Discussion Starter #3 (Edited)
I'm pretty sure that the 21 buffer wouldn't allow the cocking handle to be fully retracted to cock the hammer.
Are you sure about that. By looking at this picture it does not seem to stick out anymore than the G3 Heavy/SG1 buffer.
 

Attachments

·
Registered
Joined
·
896 Posts
It is to long, in a standard stock. But it is possible to modify the stock to take it.
 

·
Vendor
Joined
·
1,310 Posts
The diameter is to large for G3 stock

If you mean 21E buffer like in the pic they are larger dia.
The buffer hole in the G3 stock metal is to small as well.
HTH Mike
 
1 - 5 of 5 Posts
Top