HKPRO Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter · #1 ·
Hey folks
I have a couple quick questions about the HK270. I have seen them made in a few different ways. One has a grooved receiver for a scope rings, while the other is drilled for a mount. Does anyone know if a drilled receiver without the groove was done at the factory? Thanks
 

·
Registered
Joined
·
19 Posts
I have one that has the groved receiver never seen the model without groves but would like to see the receiver profile difference.

FredQ
 

·
Registered
Joined
·
2 Posts
jdm:
Sorry for the late reply, am deployed to Afghanistan and don't always have access to the internet. I own six of these rifles, from serial number 024 made in 1976 to a couple in the 5xxx series. All have the dove tail groove for scopt rings, even if they have the HK 91 front/rear sights. One even has a factory threaded barrel for a suppressor.

Badmeo1
 
1 - 3 of 3 Posts
Top