[newgunner]

Will the HK45's control lever come ambidextrous in its stock V1 configuration, I saw the "one page info" on the hk website and it said it will have ambidextrous controls.

Also will this control lever be interchangeable with the USP line?

Another question, does the compact model of the USP line have the exact same recoil reduction spring set up as HK45 and HK45c?

 

[trinydex]

Also will this control lever be interchangeable with the USP line?

i would love it if the control lever can be put on a usp... the flat ergonomically unfriendly control lever is a bit hard to actuate if you are left handed, i think because the mechanism is on the left side of the gun.

are there any "extended" safety levers out there for usp besides the hk45 one?

 

[HKP3000]

good news!!
the control levers are fully interchangeable with the USP line

 

[trinydex]

good news!!
the control levers are fully interchangeable with the USP line

thanks for the info!

is there a way to lessen the spring pressure on the control detent plate? is is this not something that is recommended?

 

[P7M8]

good news!!
the control levers are fully interchangeable with the USP line

Where did you get that information?

 

[HKP3000]

Where did you get that information?

I know the designer of the newer HK pistols quite well ;-)

 

[Geohans]

Does this mean one could take an ambi safety from a USP and put it on an HK45?

 

[HKP3000]

Does this mean one could take an ambi safety from a USP and put it on an HK45?

one could, with a little dremel work at the polymer part of the lever.
No dremel work needed when using the HK45 levers on a USP.

 

[trinydex]

one could, with a little dremel work at the polymer part of the lever.
No dremel work needed when using the HK45 levers on a USP.

so is there any way to lessen the spring tension just by a hair that holds the control detent in place?

that's pretty awesome that you know him... must be convenient.

 

[glockthegg]

Are the levers from the HK45 available for purchase somewhere?

 

[trinydex]

Are the levers from the HK45 available for purchase somewhere?

i'm lookin' too.

 

[Geohans]

Short answer is apparently no. "end of first quarter 08."