HKPRO Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
269 Posts
Discussion Starter · #1 ·
Does anyone know an easy way to get the H buffer into the hole in the A3 stock? I've tried pressing it in fairly hard with no luck.
 

·
Registered
Joined
·
184 Posts
I placed the buffer into a measuring cup full of water. I then heated the water in the microwave for two or three minutes. Be careful as the water and buffer will be hot when it comes out of the microwave. I then used a q-tip to spread a little o-ring lubricant on the tip of the buffer to help it slide in. If it does not slide in easily you can use the handle end of a screw driver and a hammer to drive the buffer in. Heating the buffer in the water lets it become softer and the lubricant aids in pushing the buffer into the stock. I have used this method on both of my A3 stocks. Good luck and Happy Holidays.
 

·
Premium Member
Joined
·
1,025 Posts
I would never have thought of that.....

Glad to know that option is available!!
 
1 - 4 of 4 Posts
Top