HKPRO Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
512 Posts
Discussion Starter #1
Bought the ambi selector for my HK45 and need help before I make a mess. I tried looking around and really only found info on the USP/C, which I understand is supposed to be close to the same. I have the grip plate off the back and the spring out, but can't figure out how to get the selector out. HELP!!!!
 

·
Registered
Joined
·
18,641 Posts
Push the sear axle to the right of the frame, but don't remove it completely, then remove the detent plate. Insert a small punch into the little groove in front of the safety lever and push down. This will allow you to rotate the safety lever to 12-o'clock position. Then just pull out the lever. If the lever doesn't come out freely, push down on the trigger bar.

You didn't have to remove the grip/lanyard loop or HS.
 

·
Registered
Joined
·
3,539 Posts
someone just did a breakdown of the of the USP video in a 5 part series that I used to install a new hammer. That should help you with the safety lever. I got stuck with the safety lever as well on the USP. I don't know the specifics on the internals on the HK45 but I image it would be close to the same.
 
1 - 4 of 4 Posts
Top