HKPRO Forums banner

1 - 6 of 6 Posts

·
Premium Member
Joined
·
8,625 Posts
What is correct way to remove/replace cocking handle/tube on MP5?
Field strip it.

Slide the cocking handle back until the roll pin lines up with the holes in the cocking tube.

Drive the pin out with a roll pin punch and hammer. The Cocking handle will come out, allowing the cocking lever support to fall out the back of the receiver.

Just be careful not to lose the detent and spring that are captured in the end of the cocking lever support.
 

·
Registered
Joined
·
1,251 Posts
Discussion Starter #3
Thanks, that is what I thought, but before I applied the hammer I wanted to double check....
 

·
Registered
Joined
·
124 Posts
Thanks, that is what I thought, but before I applied the hammer I wanted to double check....
I thought you had my phone #? If your coming to the shoot I'll fix you up.
 
1 - 6 of 6 Posts
Top