HKPRO Forums banner

How to temporarily remove control lever on HK45?

2106 Views 3 Replies 4 Participants Last post by  bones0831
Is there any easy/short way to remove the control lever on a V1 HK45 temporarily? I need to sand the back of the lever a little as it's scrapping up the frame's plastic, but am hesitant with removing lots of little pieces to do it. I'm hoping I can just pull it out and push it back in after; kind of how removal of the slide release lever is.

Thanks!
1 - 1 of 1 Posts

· Registered
Joined
·
16,174 Posts
It'll be sort of like a LEM installation. Not a 1-2 step and you're done.

In a nutshell, you'll:
- Remove lanyard pin + lanyard loop + hammer spring + hammer strut
- Remove sear axle + sear + catch + control latch + disconnector
- Remove detent plate and turn the control lever to 12-o'clock position
- Depress on the slide plate then remove the control lever
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top